Roofing Glossary: Roofing Terms in Plain English
Estimates and inspection reports are full of jargon. These definitions help you follow along and ask better questions.

What do common roofing terms mean?
Roofing terms describe the layers, edges and joints of a roof: decking is the structural base, underlayment is the protective layer, shingles or panels are the visible covering, and flashing seals joints. The glossary below covers the terms you are most likely to meet in an estimate. Questions? Call Florence Roof Care at +1 (854) 205-5010.
Parts of the roof system
- Decking: the wooden base the roof covering is fastened to; also called sheathing
- Underlayment: a protective layer between decking and the visible roofing
- Shingle: an overlapping unit of the roof covering, commonly asphalt
- Roof panel: a larger metal or other unit that forms the roof covering
- Membrane: a continuous sheet roofing material used on flat and low-slope roofs
Where water is directed
- Flashing: thin material that seals joints and openings so water runs off
- Valley: the internal angle where two roof slopes meet
- Ridge: the horizontal high point where two slopes meet
- Eave: the lower edge of the roof that overhangs the wall
- Rake: the sloped edge of a gable roof
- Drip edge: metal edging that guides water off the roof edge
- Penetration: anything that passes through the roof, such as a vent or chimney
Ventilation terms
- Soffit: the underside of the eave, often vented
- Ridge vent: a vent along the ridge that lets attic air out
- Baffle: a channel that keeps insulation from blocking airflow
- Ponding: water that stays on a flat roof after rain
See attic ventilation and roof life for more.
Terms about the job
- Tear-off: removal of the old roofing before new material goes on
- Scope of work: the written description of what will be done
- Pitch: the steepness of the roof
- Certificate of Appropriateness: approval for exterior changes in a historic district; see permit basics
- Deductible: the part of an insured loss you pay; see deductibles
Materials and roof types
- Asphalt shingle: overlapping shingles made with an asphalt-based mat; the most common residential covering.
- Three-tab shingle: a flatter shingle cut into three tabs.
- Laminated (architectural) shingle: a thicker, layered shingle with a textured profile.
- Standing seam: a metal roof with raised seams that hide fasteners.
- Exposed-fastener metal: metal panels fastened with visible screws.
- EPDM: a rubber membrane used on low-slope roofs.
- TPO and PVC: heat-welded single-ply membranes for low-slope roofs.
- Modified bitumen: asphalt-based sheet material, often torch- or adhesive-applied.
See how these affect repairs in shingle, metal and flat roof repair.
Common questions
What is the difference between decking and underlayment?
Decking is the structural base. Underlayment is a protective layer on top of it.
What is a penetration?
Any pipe, vent, chimney or skylight passing through the roof. They are common leak points.
What does scope of work mean?
It is the written list of what the contractor will and will not do.
Where can I ask about a term not listed?
Call Florence Roof Care at +1 (854) 205-5010.
Reading an estimate?
Call Florence Roof Care to be connected with an independent roofer who can explain any term in it.
Call: +1 (854) 205-5010
Florence Roof Care, 2732 TV Rd, Florence, SC 29501
Florence Roof Care · 2732 TV Rd, Florence, SC 29501 · +1 (854) 205-5010
Sources for this page: